Projects

Browse projects that ATI has worked on below.

Bridge Demolition Projects

concrete-bridge-demolition

Hurricane Harvey Emergency Bridge Repair — Humble, Texas

After water levels subsided the cleanup efforts began and life returned to normal, it was time to inspect the infrastructure and bridges in the area for any potential damage caused by the flooding.

Brazos River Bridge Demolition — Sealy, Texas

TxDOT was adding lanes on Interstate 10 between Houston and San Antonio to improve connectivity and add mobility to this important hurricane evacuation route.

Bridge Demolition Pile Cutting Shear — Logansport, Louisiana

Demolition of the Highway 84 bridge over the Sabine River, connecting Joaquin, Texas and Logansport, Louisiana.

Concrete Cutting Projects

Houston Intercontinental Airport Runway Removal — Houston, Texas

A recent project for Aggregate Technologies involved sawing and removing of thousands of square feet of runway concrete at the Houston Intercontinental Airport (IAH).

Concrete Sawing Elevator Shaft — Cypress, Texas

The new building chosen to be the Memorial Hermann Cypress Hospital required some retrofitting before final construction could continue. An interior elevator shaft was needed, but the concrete floors had already been poured.

Crawlspace Concrete Removal at Texas Medical Center — Houston, Texas

In the Texas Medical Center in Houston, Texas, facilities managers discovered a water leak in a main pipe beneath a hospital basement. The location of the pipe – encased in a concrete conduit – made access for inspecting and repair difficult. The only access was through a small crawlspace.

Concrete Demolition Projects

Chemical Demolition — Gulf Coast Region

Chemical demolition does not entail big explosions and sticks of dynamite. It is a process that relies upon expansive grout that is drilled into strategic areas of the concrete or rock to be removed.

Concrete Wharf Demolition at Port of Houston — Houston, Texas

With the Panama Canal expansion nearly complete, Wharf 2 at the Barbour’s Cut terminal of the Port of Houston is being upgraded and expanded to support larger cranes and ships.

Bridge Demolition Pile Cutting Shear — Logansport, Louisiana

Demolition of the Highway 84 bridge over the Sabine River, connecting Joaquin, Texas and Logansport, Louisiana.

Concrete Sawing Projects

Concrete Sawing Elevator Shaft — Cypress, Texas

The new building chosen to be the Memorial Hermann Cypress Hospital required some retrofitting before final construction could continue. An interior elevator shaft was needed, but the concrete floors had already been poured.

Underwater Wire Sawing and Core Drilling at Port of Houston — Houston, Texas

ATI expertise with underwater wire sawing and core drilling was on display with this renovation project.

Port Houston Wharf 3 Renovation — Houston, Texas

Aggregate Technologies was on the job for the Port Houston Wharf 3 Renovation: wire sawing, core drilling, and slab sawing.

Concrete Sawing VA Hospital — Houston

The Michael E. DeBakey Veteran’s Aadministration Medical Center (VA Hospital) in Houston is expanding its Spinal Cord Injuries and Disorders Centers (SCI/D Centers), which is one of 25 such centers around the country. The Houston VA hospital is the second largest VA hospital in the United States.

Core Drilling Projects

Hardening a Dam with Core Drilling — San Antonio, Texas

We are proud to have worked on the Olmos Dam in San Antonio, a dam that has stood since the 1920s.

Houston Airport Core Drilling — Houston Intercontinental Airport

Our core drilling experience in the City of Houston is not only limited to the sea. Our teams of engineers and contractors have also worked extensively at the biggest airport in the region.

Port of Houston Core Drilling — Port of Houston

ATI was under a time crunch with the contractor responsible for the track ready to begin their work.

Large Diameter Core Drilling at Houston Intercontinental Airport — Houston, Texas

We cut four holes, five feet in diameter, at Houston Intercontinental Airport. The holes were needed to install taxiway lights, and extreme precision was required.

Underwater Core Drilling — Gulf Coast Region

The Gulf Coast region is tied to the water. It fuels the economy and affects many different areas of commerce. From shipping to oil to fishing, underwater infrastructure keeps things moving. Any construction firm wishing to excel in the region must be uniquely prepared to perform marine work, especially underwater core drilling.

Large Diameter Core Drilling in New Orleans — New Orleans, Louisiana

Aggregate Technologies is working in New Orleans on the Caesars New Orleans casino and resort renovation project of the existing Harrah’s casino.

Port Houston Wharf 3 Renovation — Houston, Texas

Aggregate Technologies was on the job for the Port Houston Wharf 3 Renovation: wire sawing, core drilling, and slab sawing.

Core Drilling – With Bears! — Louisiana

At a salt mine renovation in Louisiana, ATI operators core drilled 91 holes, one inch in diameter and between 18 and 40 inches deep.

Large Diameter Core Drilling — New Orleans, Louisiana

Aggregate Technologies is working in New Orleans on the Caesars New Orleans casino and resort renovation project of the existing Harrah’s casino. A new hotel tower and enhanced design of the property is set to be completed by 2024.

Hydrodemolition Projects

Underwater Hydrodemolition — San Jacinto River, Texas

Torrential rain over Texas from Tropical Storm Imelda flooded the San Jacinto River. Between 11 and 14 barges came unmoored, and some collided with the Interstate 10 bridge.

Structural Beam Removal Using Hydrodemolition — Texas

Removing concrete from structural beams (while also saving the rebar) can take a lot of time, and time was of the essence.

Hydrodemolition of Bridge Deck — Gulf Coast Region

We were was called in to remove the top 1″ to 3″ of concrete over a 16,000 square foot area.

Removal of Compromised Elevated Structural Slab with Hydrodemolition — Gulf Coast Region

Compromised concrete could be catastrophic during any project! If that happens, let Aggregate Technologies ease that pain by removing just compromised area – and put you and team back on schedule and moving forward.

Pile Cutting Projects

Cutting and Removing 150 Piles a Day — Port Arthur, Texas

In addition to traditional methods of pile sawing and cutting, we use our patented pile cutting machine (pictured below) when necessary to maximize safety while keeping your project on time and on budget.

Bridge Demolition Pile Cutting Shear — Logansport, Louisiana

Demolition of the Highway 84 bridge over the Sabine River, connecting Joaquin, Texas and Logansport, Louisiana.

Robotic Hammering Projects

Interior Structural Demolition — Houston, Texas

ATI operators completed interior structural demolition work at Baptist Temple Church in the historic Heights neighborhood in Houston, Texas.

Slab Sawing Projects

Double Tee Slab Sawing — Houston, Texas

We helped complete a renovation project at the George R. Brown Convention Center in downtown Houston.

Port Houston Wharf 3 Renovation — Houston, Texas

Aggregate Technologies was on the job for the Port Houston Wharf 3 Renovation: wire sawing, core drilling, and slab sawing.

Underwater Demolition Projects

Underwater Hydrodemolition — San Jacinto River, Texas

Torrential rain over Texas from Tropical Storm Imelda flooded the San Jacinto River. Between 11 and 14 barges came unmoored, and some collided with the Interstate 10 bridge.

Underwater Wire Sawing and Core Drilling at Port of Houston — Houston, Texas

ATI expertise with underwater wire sawing and core drilling was on display with this renovation project.

Underwater Core Drilling — Gulf Coast Region

The Gulf Coast region is tied to the water. It fuels the economy and affects many different areas of commerce. From shipping to oil to fishing, underwater infrastructure keeps things moving. Any construction firm wishing to excel in the region must be uniquely prepared to perform marine work, especially underwater core drilling.

Wall Sawing Projects

Structural Slab Removal at Rice University — Houston, Texas

Aggregate Technologies, Inc. was recently contracted for a job at Rice University in Houston to remove a second floor structural slab for a new stairwell.

Precast Wall Removal — Pasadena, Texas

The plan to upgrade a neighborhood HEB grocery to a Super HEB in Pasadena, Texas called for several tilt wall panels to be removed and demolished.

Wall Sawing Openings for Windows — Houston, Texas

Clients can’t afford contractors who interfere with their ability to conduct business. With that in mind, they trust Aggregate Technologies, Inc. to complete their concrete cutting projects safely, quickly, and without disrupting day-to-day operations.